Hello everybody,
i have a question about pulling codes from a MAS Module on a 1990 W126 300SE with the X11/4 8 Pin Connector.
My problem is, that when i purchased the car in 2020 the KOEO Duty Cycle was 70% (as it should be).
Now it is 50% static, but when the engine is warm it is fluctuating as it should.
There are no fault codes saved in the CIS ECU, so now i thought that it would be interesting to know if there are any in the MAS.
But the manual only states that i need...
Reading MAS Codes on 90' W126 300SE - X11/4 8 Pin Connector - 50% KOEO Duty Cycle
i have a question about pulling codes from a MAS Module on a 1990 W126 300SE with the X11/4 8 Pin Connector.
My problem is, that when i purchased the car in 2020 the KOEO Duty Cycle was 70% (as it should be).
Now it is 50% static, but when the engine is warm it is fluctuating as it should.
There are no fault codes saved in the CIS ECU, so now i thought that it would be interesting to know if there are any in the MAS.
But the manual only states that i need...
Reading MAS Codes on 90' W126 300SE - X11/4 8 Pin Connector - 50% KOEO Duty Cycle
---------------------------------------------------------------------------
Visit this link to stop these emails: https://zpr.io/t5iAW